#1. Success and fails to turn the light on LED

My very first experience to play with a breadboard and LED!

Sometimes LED is lighten up, sometimes it did not work, but haven’t found the reason. I thought I connected between power and ground with wired properly, but guess there are some mistakes.

 

My first attempt was failed. Anybody please explain the reason.

 

kakaotalk_photo_2016-09-14-16-05-14_22

I changed the arrangement of elements and it worked successfully.

kakaotalk_photo_2016-09-14-16-05-12_32

I made another shape of circuit.

kakaotalk_photo_2016-09-14-16-05-08_46

 

In the same circuit, I added one more LED next to the previous one, but…

I should not have put it just next to the first one? Current can not flow between LEDs directly from one another? I will connect with a wire between two of them. We’ll see.

kakaotalk_photo_2016-09-14-16-05-10_16

 

3 thoughts on “#1. Success and fails to turn the light on LED”

  1. Hey Jinhee, congratulations on building your first circuit! The issues you are having are about getting a handle on how the breadboard holes are actually connected, so it is normal! It might take a bit of practice. We can discuss this more in person. Also, using a multimeter to check for continuity or voltage flowing through will be very helpful for troubleshooting. Good luck!

Leave a Reply